GE Monogram ZDOD240 owner manual For your safety Door gasket, In the event of a power failure

For your safety

Door gasket

Light bulb replacement

In the event of a power failure

Care and Cleaning

Outdoor/Indoor Refrigerator

Turn the outdoor/indoor refrigerator OFF or unplug the unit before cleaning.

Turn the outdoor/indoor refrigerator OFF by pressing the button on the control panel a minimum of 3 seconds until the light and temperature display turn off.

The vinyl gasket may be cleaned with mild	After cleaning the door gasket, apply a
soap and water, a baking soda solution or	thin layer of paraffin wax or petroleum
a mild scouring powder. Rinse well.	jelly to the door gasket at the hinge side.
	This helps keep the gasket from sticking
	and bending out of shape.
Turn OFF or unplug the outdoor/indoor	To remove the light shield, push in the tab
refrigerator before replacing the light bulb.	on the left side of the shield and lower it.
	Replace with a 15 watt appliance bulb.
If power fails, you can maintain interior	Do not store or use gasoline or other
temperature longer by keeping the door	flammable vapors and liquids in the
closed. Open the door only when necessary	vicinity of this or any other appliance.
to avoid the loss of cold air.

Preparing for vacation

For long vacations or absences,

always leave the unit running with the temperature set at 45°F (7.2°C). This will provide the greatest degree of protection to your outdoor/indoor refrigerator. In addition to leaving your unit turned on, it is recommended that you follow the below steps prior to long vacations. If you cannot leave your unit turned on during extended periods of non-use, be sure to follow the below steps.

1.Remove all the contents from the unit.

2.Clean the outside and inside (see instructions on the next page).

3.Place charcoal and baking soda inside the unit. In conditions which are either below 45°F (7.2°C) or high humidity, use 4 lbs. baking soda. In all other conditions, use 1 lb. baking soda.

4.Cover the unit with the Monogram vinyl cover.

A vinyl cover accessory is available to protect the outdoor/indoor refrigerator during extended periods of non-use. The durable vinyl exterior withstands the elements and the soft felt lining helps protect the stainless steel finish. There is one that fits a built-in installation or one for free-standing use. In addition to the vinyl cover, an embroidered Monogram polishing cloth is available. Use the polishing cloth to keep the refrigerator’s stainless steel finish clean.

ZBKTF – for free-standing installation ZBKTB – for built-in installation ZPOL – for Monogram polishing cloth

Call 800.626.2002 to order.

For shorter vacations, remove perishable foods and leave controls at regular settings. However, if the ambient temperature is expected to drop below 45°F (7.2°C), follow the same instructions as for long vacations.

Preparing to move

Secure all loose items such as shelves and	Be sure the outdoor/indoor refrigerator
drawers by taping them securely in place	stays in an upright position during moving.
to prevent damage.

12