Installation Preparation
Beverage Center & Wine Chiller
Reverse
Door
Swing
To remove the door:
•Remove the top hinge pin using a 1/8" Allen wrench. Set aside.
•Lift the door off the bottom hinge.
•Remove the top hinge and set aside.
•Remove the bottom hinge, the plastic washer and the bottom hinge pin using a Phillips screwdriver.
•Install the Phillips hinge pin in the top hinge and
•
•Install the Allen wrench hinge pin in the bottom hinge and
•Insert the supplied plug buttons into the old hinge holes, top and bottom.
The light trigger on the bottom of the door must be removed and secured to the opposite end.
•Remove the light trigger by backing out 2 screws. Set the trigger and screws aside.
•Install screws from plastic bag packed with Owner’s Manual into light trigger holes.
•Turn the door upside down.
•Measure and mark
•Drill holes with 5/32" drill bit.
•Install the light trigger with original screws.
•Remove the top hinge pin using the 1/8" allen wrench.
•Place the door onto the bottom hinge, and install the top hinge pin with allen wrench.
•Open and close door to test door swing. If door drags and does not close evenly, loosen hinge screws and slip shims behind the hinge. Tighten screws and test again.
Position new nameplate:
•Remove the original nameplate, now located on the bottom of the door.
•Locate the template on the back of this instruction book.
•Hold or tape template behind glass door.
•Remove backing from Monogram name- plate.
•Place nameplate onto front side of door, matching illustration on template.
Slip Shim
Behind Hinge
Top Hinge
Bottom Hinge
Light Trigger
Top of the Door
11/16" 3/4"
Front of the Door
Upper Left |
|
|
Corner of |
|
|
Glass | Top |
|
| of Name | Top of |
| Plate | |
|
| Glass Door |
DOOR |
|
|
NAME PLATE |
|
|
LOCATION |
|
|
Door |
|
|
Frame Side |
|
|
P/N |
|
|
41005263 |
|
|
5
