Design Guide

THE INSTALLATION SPACE

NOTE:

Handle and handle standoff depth is 1-3/4"

*For a standard installation of Custom-Framed unit: The product must be installed so that the front face will project 2" forward of adjacent cabinets. This position will allow a full door swing and prevent interference with adjacent cabinetry. The opening between cabinets must be 23-3/4" minimum.

*For a standard installation of Stainless Steel unit: The product must be installed so that the front face will project 1-3/4" forward of adjacent cabinets. This position will allow a full door swing and prevent interference with adjacent cabinetry. The opening between cabinets must be 23-3/4" minimum.

**For a flush installation of Stainless Steel unit: Install a 1/2"-wide filler strip on the hinge side. The filler strip will act as a spacer between the door case and adjacent cabinets and will prevent interference with the cabinet door swing. Recess the filler strip 2" back from the front face of the unit, or even with the front edge of the product case (behind the gasket). The width of the opening must be 24-1/4" (including the 1/2" filler strip).

***For a flush installation of Custom-Framed unit: Install a 1"-wide filler strip on the hinge side. The filler strip will act as a spacer between the door case and adjacent cabinets and will prevent interference with the cabinet door swing. Recess the filler strip 2" back from the front face of the unit, or even with the front edge of the product case (behind the gasket). The width

of the opening must be 24-3/4" (including the 1" filler strip).

•The wine chiller, wine reserve and beverage center can be installed freestanding.

Additional Specifications

•A 120 volt 60Hz., 15 or 20 amp power supply is required. An individual properly grounded branch circuit or circuit breaker is recommended. Install a properly grounded

3-prong electrical receptacle recessed into the back wall as shown. Electrical must be located on rear wall as shown. NOTE: GFI (ground fault interrupter) is not recommended.

THE INSTALLATION SPACE (cont.)

 

Flush

 

 

 

Installation

 

Dim. A

 

Filler panel or cleat

 

 

to be set back even

 

 

with front of case.

 

CABINET

Front edge of product case

CABINET

 

Front face

 

110°

These products will fit flush to

120°

 

adjacent cabinets when installed

 

 

with a Dim. A-width filler panel

 

 

or cleat. The filler panel should

 

 

be recessed or set back behind

 

 

the door and even with the front

 

 

edge of the product case.

 

 

 

Product

 

Dim. A

 

ZDWI240, ZDBI240

1"

 

 

ZDWC240, ZDWR240

1/2"

 

 

ZDBC240, ZDBR240

1/2"

 

 

Standard

Installation

CABINET

Front edge of product case

CABINET

 

 

Dim. A

Front face

 

 

 

110°

 

In a standard installation,

120°

 

the product will project forward

 

of adjacent cabinets. See Dim. A.

 

Product

Dim. A

ZDWI240, ZDBI240

2"

ZDWC240, ZDWR240

1-3/4"

ZDBC240, ZDBR240

1-3/4"

3