GE Monogram ZEK735 manual Questions?, Use This Problem Solver, Possible Cause

Models: ZEK735

1 36
Download 36 pages 62.79 Kb
Page 32
Image 32
QUESTIONS?

 

QUESTIONS?

USE THIS PROBLEM SOLVER

 

 

PROBLEM

POSSIBLE CAUSE

 

 

“F–AND A NUMBER

• This is a function error code. Press CLEAR/OFF. Allow the oven to cool one

OR LETTER” FLASH

hour. Place the oven back into operation.

IN THE DISPLAY

• Disconnect all power to the oven for 5 minutes and then reconnect power. If the

 

 

failure code repeats, call for service.

 

 

CONTROL SIGNALS AFTER

• This is reminding you to press BAKE and then enter a bake temperature.

ENTERING COOKING TIME

• This is reminding you to enter a bake temperature after having pressed BAKE.

OR DELAY START TIME

 

 

 

DISPLAY GOES BLANK

• The circuit breaker in your house has been tripped, or a fuse has been blown.

 

 

DISPLAY FLASHES

• Power failure. Reset the clock.

 

 

UNABLE TO GET THE

• BAKE and BROIL HI/LO must be pressed at the same time and held for

DISPLAY TO SHOW “SF”

2 seconds.

 

 

“PROBE” APPEARS IN

• The probe is not inserted properly into the oven receptacle or food.

THE DISPLAY

• This is reminding you to enter a probe temperature after plugging in the probe.

 

 

 

“LOCK DOOR” FLASHES

• Oven door not closed after self-clean cycle is selected.

 

 

“LOCKED DOOR” FLASHES

• Door is still locked and you are trying to enter an oven cooking operation.

 

 

OVEN LIGHT DOES

• The light bulb is loose or defective. Tighten or replace.

NOT WORK

• The pad operating the oven light is broken. Call for service.

 

 

 

OVEN WILL NOT SET A

• Oven temperature is too high to set self-clean operation.

SELF-CLEAN CYCLE

Allow the oven to cool to room temperature and reset the controls.

 

• The probe is plugged into the outlet in the oven. Remove the probe from the oven.

 

 

OVEN NOT CLEAN

• Oven controls not set properly. See the Operating the Self-Cleaning

AFTER CLEAN CYCLE

Oven section.

 

• Heavily soiled ovens require 4 to 5 hours of clean time.

 

• Heavy spillovers should be cleaned up before starting clean cycle.

 

 

DOOR WILL NOT

• When the temperature has fallen below the locking temperature door can

OPEN AFTER

be opened.

SELF-CLEAN CYCLE

 

 

 

32

Page 32
Image 32
GE Monogram ZEK735 manual Questions?, Use This Problem Solver, Possible Cause