Installation
Outdoor Cooki_g (enters
ELECTRICAL |
| SUPPLY |
|
|
|
|
|
| DO NOT | UNDER | ANY CIRCUMSTAN(:ES, | ||||||||||||
Models | with | rotisserie | require | 120V, | 60Hz. | CUT OR REMOVE THE THIRD | (GROUND) | ||||||||||||||||
and | cmmected |
| to | an individual | properly |
| PRONG FROM THE POWER CORD. |
| |||||||||||||||
grounded | branch | circuit protected | by a | 15 |
|
|
|
|
|
|
|
|
|
|
| ||||||||
amp | circuit |
| breaker | or | time | delay | filse. |
| • | For | 27" | wide | grills, | locate | the |
| |||||||
The | power | cord | on the | rotisserie |
| is equipped |
| electrical | outlet | on | the | left | hand | side | within | ||||||||
with | a | (grotmding) |
| plug | which |
| reach | of | the | rotisserie's | 72" | power | cord. | ||||||||||
mates |
| with | a | standard |
| grotmding | • | For | 36" | and | 48" | wide | grills, locate | ||||||||||
wall | receptacle |
| to | minimize | the | possibility | of |
| the electrical | outlet | on the | right | hand | side | |||||||||
shock |
| hazard | fi_om this appliance. |
|
|
|
|
| within reach | of | the | rotisserie's 30" power | |||||||||||
If the electrical service provided does not |
| cord. |
|
|
|
|
|
|
|
|
| ||||||||||||
|
|
|
|
|
|
|
|
|
|
| |||||||||||||
meet |
| the above | specifications, | it |
| is recom- |
|
|
|
|
|
|
|
|
|
|
|
| |||||
mended that a licensed electrician install an |
|
|
|
|
|
|
|
|
|
|
| ||||||||||||
approved | outlet. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
St
es[Jo "
Leaks
TEST FOR LEAKS
A complete gas tightness check must be
pertormed at the installation site.
•Do not use the grill tmtil all com_ections have been leak tested.
•Repeat leak test alter each LP tank change.
•Check to be sm'e the main valve on the LP tank or the
•Make a soap solution of one part liquid
detergent and one part water.
The valve panel must be removed to check the valves and fittings.
•All control valves should be in the "OFF" position.
•Relnove the knobs.
•On inodels equipped with Rotisserie, relnove
the satety valve pushbutton and tmsrrew the
stn'rotmding bezel.
•Rem()ve the 4 screws holding the valve panel to the grill.
•Pull the panel outwards and m_plug the wires fl'om the back of the rotaI T igniters.
•If the grill has an optional rotisserie bm'ner,
remove the screws holding the inspection cover in place.
TO TEST:
• Apply the soap solution arotmd the
com_ections, valve and tubing.
•Tm'n the gas supply on.
•Check all comaections fi'om the supply line
or LP tank up to and including the manifl_ld pipe assemblv.
•If a leak is detected, turn gas supply to off and tighten fittings. Tm'n the gas on and check again.
•To
original screws.
10