GE Monogram ZICP360NX dimensions GE Monogram 36 Professional Built-In Bottom Freezer Refrigerator

ZICP360NX

GE Monogram® 36" Professional Built-In Bottom Freezer Refrigerator

Dimensions and Installation Information (in Inches)

The Installation Space

The finished cutout width must be 35-1/2".

35-1/2"

Finished Width

2-5/16" Wall View

Door Swing Clearances

The installation must allow for clearances to adjacent walls or cabinets. These refrigerators are equipped with a 2- position door stop. The factory-set 130° door swing can be adjusted to 90° if clearance to adjacent cabinets or walls is restricted.

								6"
				10"				Electrical
84-1/2" max								Area		75" From
83-1/2" min			24" Cutout Depth							Floor to Bottom
Finished										of Electrical
Opening					Cold Water					Area
		5"							5"
							Supply			Note: Icemaker
										water connectio
	3 1/2"					3 1/2"				is at the front.

130° Door Swing

130°

25" Min. to

Wall

	23	-	7/8"
90° Door Swing	Behind
	Frame

36-3/4"

90°

5" Min. to Wall

The cutout depth must be 24"

The refrigerator will project forward, slightly beyond adjacent cabinetry, depending on your installation.

The cutout depth beneath a soffit

When installed beneath a soffit, the soffit cannot exceed the 24" installation depth shown. The top case trim overlaps the bottom of the soffit.

Allow 25" minimum clearances for a full 130° door swing. Allow 15" for pan removal.

•5" minimum clearance is required when the door swing is adjusted to 90°. If the 90° door stop position is used, pan access is maintained, but pan removal is restricted.

Electrical

Product Dimensions 35" Case Width 25-3/4" Case Depth

A 115V, 60Hz., 15 or 20 amp power supply is required. An individual properly grounded branch circuit or circuit breaker is recommended. Install a properly grounded 3-prong electrical receptacle recessed into the back wall. Electrical must be located on rear wall as shown.

Note: GFI (ground fault interrupter) is not recommended.

Water Line

The water line can enter the opening through the floor or back wall. Route GE SmartConnect™ Kit or 1/4" O.D. copper tubing between the cold water line and the water connection location at the front of the refrigerator. The tubing must be long enough to extend to the front of the refrigerator. The installation of an easily accessible shut-off valve in the water line is required.

For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service, 800.626.2000.

*Shipping Height: The refrigerator can be adjusted to fit into a cutout that is 83-1/2" min. to 84-1/2" max. height. The top case trim at the front

is 1/2" higher and will overlap upper cabinetry or soffit. Use leveling legs and wheels for a maximum 1" height adjustment.

	84"* from
	floor to	*Sh
83-1/2"*	top frame	re
at Rear		to
		83
		he
		tr
		an
		or
		an
		1"
	36" Frame to
	Frame Width
28-11/16" Depth Including Handles

Listed by Underwriters Laboratories

Specification Created 6/08 110113