GE Monogram ZIC360N LH Remove Packaging, Install Water Line, Shut off the main water supply

Installation Instructions

STEP 1 REMOVE PACKAGING

CAUTION: Refrigerator is much heavier at the top than at the bottom – be careful when moving. When using a hand truck, handle from side only.

PRUDENCE: Le réfrigérateur est beaucoup plus lourd en haut qu'en bas. Il faut être prudent lors des déplacements. Si un diable est utilisé, il faut soulever le réfrigérateur sur le côté seulement.

•Carefully cut banding at the top and bottom, remove outer carton.

•Slide out back corner posts (2).

•Slide carton off top of cabinet.

NOTE: IT IS NOT NECESSARY TO LAY CABINET DOWN IN ORDER TO REMOVE SKID!

•The unit is secured to the skid with 4 slotted tie-down straps. Remove the four 5/16" bolts from the base channels in the tie-downs.

• Remove the four 7/16" bolts securing the straps to the skid.

CAUTION: DO

NOT ATTEMPT TO

ROLL UNIT OFF SKID.

Toekick	Remove	PRUDENCE: IL
	Tie-Downs
		NE FAUT PAS ESSAYER
		DE FAIRE ROULER LE
		RÉFRIGÉRATEUR POUR
		L'ENLEVER DE LAY
		PALETTE.

•Support blocks on the bottom of the refrigeration case must be removed before sliding unit off skid or damage will occur. Carefully, tilt refrigerator and slide blocks out from beneath, slide unit off skid.

•Remove toekick. Set aside for final installation.

STEP 2 INSTALL WATER LINE

•A cold water supply is required for automatic ice- maker operation. The water pressure must be be- tween 40 and 120 p.s.i.

•Route 1/4" OD copper tubing between house cold water line and the water connection location.

•Copper tubing should be long enough to extend to the front of the refrigerator. Allow enough tubing to accommodate bend leading into the water line connection.

Shut off the main water supply.

Turn on the nearest faucet long enough to clear the line of water.

•Install a shut-off valve between the icemaker water valve and cold water pipe in a basement or cabinet. The shut-off valve should be located where it will be easily accessible.

NOTE: It is best to install the valve into a vertical water pipe. If you install the valve into a horizontal water pipe, make the connection at the top or side, to avoid drawing off any sediment from the water pipe.

•Drill a 1/4" hole in the water pipe.

•Fasten the shut-off valve to the pipe with pipe clamp.

•Tighten the clamp screws until the sealing washer begins to swell. Do not over tighten.

•Place a compression nut and ferrule (sleeve) onto the end of the tubing and connect it to the shut-off valve. Make sure the tubing is fully inserted into the valve and ferrule is tightened.

•Turn on the main water supply and flush debris. Run about a quart of water through the tubing into a bucket. Shut off water supply at the shut-off valve.

Floor

Copper Tubing

Compression Nut

Saddle Type

Shutoff Valve

Packing Nut

Outlet Valve

Ferrule (Sleeve)

NOTE: Saddle type shut-off valves are included in many water supply kits. Before purchasing, make sure a saddle type valve complies with your local plumbing codes.

NOTE: Commonwealth of Massachusetts Plumbing Codes 248CMR shall be adhered to. Saddle valves are illegal and use is not permitted in Massachusetts. Consult with your licensed plumber.

10