Installation Instructions

STEP 7 ADJUST DOOR SWING

NOTE: This refrigerator has a 2-position door stop. When space does not allow the door to swing open fully to 130°, you may change the door swing to a 90°

opening. Skip this step if door opening is satisfactory for your installation situation.

Lift the grille panel to access the wire cover trim.

Remove screws on both sides of the wire cover trim and lift off.

Use pliers to unscrew door stop and reinstall into the 90° position.

STEP 8 INSTALL GRILLE PANEL

• Raise the grill panel to stop position.

 

Raise

 

Loosen

Grille

Loosen

Panel

Side

Side

 

Trim

 

Trim

Screw

 

Screw

 

Adjust Nut Below

 

 

Spring to Accommodate

 

 

Panel Weight

 

Remove

Wire Cover

Trim Screws

Pin Location For

90°Door

Swing

Pin Location

as Shipped

130°Door Swing

Loose screws on side trim behind frame. Remove bottom trim.

Slide panel over the metal baker panel and into the trim.

•Ê If necessary, tap with a wood block until panel slips under the top trim piece.

Reassemble bottom trim. Tighten screws.

Adjust the hinge spring to accommodate the panel weight, if necessary.

• Reinstall the wire cover trim.

13

Page 13
Image 13
GE Monogram ZICS360N LH, ZICS360N RH, ZIC360N LH, ZIC360N RH installation instructions Adjust Door Swing, Install Grille Panel