GE Monogram ZIRS360NXRH dimensions Cutout and Clearances for Multiple Product Installations

ZIRS360NX

GE Monogram® 36" Built-In Integrated All-Refrigerator

Dimensions and Installation Information

Cutout and Clearances for Multiple Product Installations

ZUGSS2: For side-by-side installation of two stainless steel wrapped models. This kit provides a unified stainless steel grille panel to span the width of two units.

For a complete food storage center, install a Monogram All-Refrigerator and All Freezer side-by-side. For even more capacity, install two refrigerators or two freezers.

				0"
	25"						25"
Min.		to				Min. to
Wall			130ϒDoor Swing		130ϒDoor Swing	Wall

If you are installing two units, side by side, the installation space must be 71-1/2" wide. Additional cutout width may be required when side panels are used. Add side panel thickness to the finished cutout to calculate rough-in width.

•The water and electrical locations for each product must be located as shown.

•A separate 115V, 60Hz., 15 or 20 amp power supply is recommended for each product.

5"

Clearances for Multiple Single Door Installations

In a side-by-side installation of a left and right door swing product, the inside trims touch at the front, with a 1" clearance between the units at the rear. Order ZUGSS2 Unified Grille Panel Kit for one continuous grille panel.

For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service, 800.626.2000.

Clearances for two products installed side-by-side with right and left side hinges together

Allow 5" minimum between the two products to prevent one door from striking the other. Use the WX14X99 adjustable door stop to reduce the factory set 130˚ door swing and to allow pan removal. NOTE: A unified grille panel kit will NOT fit this installation.

Listed by

Underwriters

Laboratories

Specification Created 6/08 110163