12
Installation
36" Stainless Steel Refrigerators, Freezers
Step 8
Connect
Power
• Connect the power cord plug to properly grounded
receptacle, accessible through the top left side of the
hood opening.
• Check to make sure power is on by opening the door
to see if interior lights are on.
Step 9
Mount
Top Grille
Panel
For shipping purposes, the top case trim is secured at
84" installation height.
To raise case trim to 84-1/2" installation height or to
lower case trim to 83-1/2":
• Loosen 2 screws on both sides and raise or lower
the top case trim to meet soffit height or to the top of
adjacent cabinets.
• Tighten all 4 screws.
• Mount the grille panel by dropping into slots on the
case trim.
The grille panel assembly is factory set for an 84"
installation height. If installation height is 83-1/2" or
84-1/2", order ZGCSS36RH (right hand) or ZGCSS36LH
(left hand) grille panel kit.
Important:
Maintain 1-1/2" min. gap between top of
doors and bottom of grille panel.
1-1/2" min. gap
Step 10
Adjust Door
Alignment
Check door alignment. The top of the door should be
parallel with the grille panel. If the door appears to be
too high or too low on the handle side, adjustments
can be made by turning the hinge.
• To raise the door, turn adjustable hinge pin towards
the right.
• To lower the door, turn hinge pin towards the left.
Turn the hinge pin with a 5/16" wrench or, on some
models use the 3/16" Allen wrench taped to the hinge.
Door Should be Parallel
With Grille Panel
Bushing
Door Hinge
Case Hinge
5/16" Wrench
Raise
Pin Shoulder