6
Installation Preparation

36" Stainless Steel Refrigerators, Freezers

These models are factory set for 84" installation height.
Adjustments to 83-1/2" or 84-1/2" heights can be made
by changing the grille panel.
Order ZGCSS36RH (right hand) or ZGCSS36LH (left
hand) Grille Panel Kit. These kits include 2 grille panels,
for 83-1/2" and 84-1/2" installation heights.
Accessory
Grille Panel
Kits
Electrical and
Water
Connection
Locations
The water line can be routed through
the floor or back wall.
• The icemaker water line should be:
–Approximately 3-1/2" from the floor on the back wall,
or 3-1/2" from the back wall on the floor.
–At least 5" from either side of the opening.
A 115 volt, 60 Hz. 15 or 20 amp power supply
is recommended. An individual properly grounded
branch circuit or circuit breaker is recommended, as
noted on the rating plate.
• Locate the electrical outlet within 5" x 7" shaded area
shown.
–2-1/2" from the left side.
Between 74" and 81" from the floor.
Clearances
Important:
To insure a flush fit and access to the power
cord, locate the electrical outlet as shown.
ZUGSS Unified Grille Panel Kit
For side by side installation, order ZUGSS grille panel
kit. This kit provides one continuous panel to span the
width of two products installed together for a unified
appearance.

Water Location

3 1/2"

5"

7"

5"

Electrical Outlet

Location 2 1/2"

74"

When installed into a corner: Allow 15" clearance on
the hinge side for a 130° opening and full extension of
bottom pans and pan removal.
Two products installed side-by-side, both with hinges
on left sides (or right sides) will require a 2" min.
clearance between the products. The 2" min. separation
will prevent one door handle striking the handle on the
opposite product.