Troubleshooting
Advantium Oven
Questions? Use this
problem solver
Problem
LIGHTS
Light during a speedcook cycle dims and cycles on and off, even at full power levels
Light visible around the door and outer
case while speedcooking
Possible Causes
This is normal.
Power level has been
automatically reduced because the oven is hot.
This is normal.
What To Do/Explanation
•This is normal. The oven senses the heat level and adjusts automatically.
•When the oven is on, light may be visible around the door and outer case.
FAN
Fan continues | to run | The oven is cooling. | • The fan will automatically | shut | off | |||
after | cooking | stops |
| when | the internal parts | of the | oven | |
|
|
|
|
| have | cooled. |
|
|
Oven | vent | emits | This is normal. |
|
|
|
| |
warm | air | while |
|
|
|
|
|
|
oven | is on |
|
|
|
|
|
|
|
Fan comes on
automatically when using the microwave
COOKING
The oven makes unusual sounds while cooking
This is normal.
Clicks and fans blowing • These sounds are normal. are normal. The relay
board is turning the components on and off.
Smoke comes out of the oven when I open the door
Food is not fully cooked or browned
at the end of a program
SENSOR ERROR displayed along with an oven signal
Food is high in fat content. Aerosol spray used on the pans.
Programmed times
may not match the size or amount of food you are cooking.
Food amount or type placed in the oven does not match the program that was set.
Steam was not sensed by the oven because plastic wrap was not vented, a lid too tight was on the dish or a liquid was covered.
•Smoke is normal when cooking
Increase or decrease time for doneness or adjust the upper or lower lamps for browning and cooking doneness.
•Press the CLEAR/OFF pad. Set the oven program to match the food or liquid to be cooked or heated.
o Vent plastic wrap, use a looser lid or uncover liquids when cooking or heating.
39
