ADJUSTING THE VIDEO QUALITY
The 1:2 Component Audio Over CAT5 receiving unit can adjust both the brightness and focus of the reproduced video signal. Differences in cable skew and distance are factors that can affect these settings. To adjust these settings and tune the video signal please use the steps below.
Brightness
If the image appears too dim or too bright, adjust the brightness trim pot on the front of the Component/Audio Receiver.
Insert a small flathead device into the brightness trim pot hole and turn the trim pot in either a clockwise or counterclockwise direction. Turn the trim pot in very small increments until the desired brightness is reached.
Focus
If the image is out of focus, or the colors are smeared, adjust the focus trim pot on the front of the Component/Audio Receiver.
Insert a small flathead device into the focus trim pot hole and turn the trim pot in either a clockwise or counterclockwise direction. Turn the trim pot in very small increments until the image clears and there is not blurriness or smearing.
9
