RS-232 SERIAL CONTROL COMMANDS

2. USING SHORT-CUT CHARACTERS TO CHANGE SETTINGS

2.1 HYPERTERMINALtm SETTINGS in Microsoft Windowstm

First, please set up the correct communication configuration by running these commands (as shown on the screen shot immediately below):

File->Properties->Setting->ASCII Setup

Also, please be sure to unmark the check box that says “Send line ends with line feeds.”

2.2 EXAMPLE -- CHANGE THE ROUTED SOURCE

Now you are ready to route Display input sources.

At the Hyperterminal cursor prompt, type the numeral key of the input to switch to, followed by the ENTER key.

Wait until you see the message “Function Done” on the Display. At this point the Display should show the correct Source corresponding to the numeral that was typed.

21

Page 24
Image 24
Gefen EXT-DVIKVM-441DL Using SHORT-CUT Characters to Change Settings, HYPERTERMINALtm Settings in Microsoft Windowstm