CONNECTING AND OPERATING THE 1:5 SPLITTER FOR HDMI OVER CAT-5

How to Connect the 1:5 Splitter For HDMI Over CAT-5

1.Connect the HDMI source device to the 1:5 Splitter For HDMI Over CAT-5 sender unit using the supplied HDMI cable.

2.Connect up to 4 of the HDMI outputs to the HDMI jumper inputs using the supplied short HDMI jumper cables. The fifth port can be used for local HDMI output to a display. Alternately, any or all output ports can be used to route HDMI to local displays, bypassing the HDMI extension feature.

3.For each HDMI extension, connect a pair of user supplied CAT-5, CAT-5e or CAT6 cables between an open pair of RJ-45 extension ports on the sender and the pair of RJ-45 ports on a receiver.

NOTE: When field terminating CAT cable, please adhere to the TIA/EIA- 568-B specification. Please see page 11 for details.

4.Connect a HDMI capable display to the receiver using a user supplied HDMI cable.

5.Connect the included 24V DC power adapter to the sending unit and one of the included 5V DC power adapters to each of the receivers.

6.Power on the displays first and then the source device.

NOTE: Video may not immediately appear. If this is the case, please refer to the next section for instructions on how to change EDID modes and adjust equalization.

8

Page 11
Image 11
Gefen EXT-HDMI-CAT5-145 user manual How to Connect the 15 Splitter For Hdmi Over CAT-5