Gefen GTV-HDMI-CAT5LR Configuring The Extender For Hdmi Long Range, Distance Control, Dip Switch

CONFIGURING THE EXTENDER FOR HDMI LONG RANGE

The Extender for HDMI Long Range receiver has adjustment settings that may need to be made before an optimal video quality is achieved. The available adjustment options are listed below.

Distance Control

The Dip Switches related to distance control will allow the user to set the proper signal output for the length of CAT-5 cable used with the Extender for HDMI Long Range system. Please use the table below to set the proper setting:

Cable Length	Dip Switch Setting
	Dip Switch 1	Dip Switch 2
0 - 165 Feet	OFF	OFF
166 - 330 Feet	ON	OFF
331 - 495 Feet	OFF	ON
496 - 820 Feet	ON	ON

NOTE: These length settings are guidelines. Actual settings may vary depending on the quality of cabling used. If there is no image after using the recommended settings above, please try the setting listed either below or above the one currently being used.

Equalization

The equalization Trim Pot will eliminate video noise that may be present in the video signal. Follow the steps below to adjust the equalization:

1.Locate the equalization Trim Pot on the front panel of the receiver and insert a small adjustment tool, such as a small flat headed screwdriver, into the hole.

2.Turn the Trim Pot in either a clockwise or counter-clockwise direction until the video noise is eliminated.

3.Remover the adjustment tool.

Gain (Brightness)

The gain Trim Pot will control the brightness level of the video signal. Follow the steps below to adjust the gain:

4.Locate the gain Trim Pot on the front panel of the receiver and insert a small adjustment tool, such as a small flat headed screwdriver, into the hole.

5.Turn the Trim Pot in either a clockwise or counter-clockwise direction until the desired brightness is achieved.

6.Remover the adjustment tool.

9