To fine tune a cue point, pause play at the memorized cue point, then use the SEARCH BUTTONS (7) to scan frame by frame (1/75th of a second) to where you want play to begin. Press the PLAY/PAUSE BUTTON (9) to save the new cue point.
Note: During fine tuning there will be a stutter effect (to help you find the beat). The stuttering effect will end when you press the PLAY/PAUSE BUTTON (9) to save the cue point. Also, during fine tuning if you hold down the SEARCH BUTTONS (7), the unit will scan quickly after 10 frames.
TROUBLE SHOOTING
•If the disk will not play, check to see if the disc was loaded correctly (label side up). Also check the disc for excessive dirt, scratches, etc.
•If the disc turns but there is no sound, check the cable connections. If they are okay, check your amplifier or receiver.
•If the CD skips, check the CD for dirt or scratches. Do not assume that the CD player is defective. Many CDs are recorded out of spec and will skip on most or all CD players. Before sending the unit in for repair, try playing a CD that you are sure plays properly.
SPECIFICATIONS
GENERAL: |
|
|
Disc Type | Standard Compact discs (12 cm & 8 cm) | |
Time Display | Track Elapsed, Track Remain, or Total remain | |
Variable Pitch | +/- 16% Slider with Resume Switch | |
Start | Within 0.03 seconds | |
Track Selection | 1 to 99 Tracks | |
AUDIO SECTION: |
|
|
Quantization | 1 Bit Linear/Channel, 3 Beam Laser | |
Oversampling Rate | 8 Times | |
Sampling Frequency | 44.1 kHz | |
Frequency Response | 20 Hz to 20 kHz | |
Total Harmonic Distortion | Less Than 0.005% | |
Signal to Noise | Ratio | >96 dB |
Dynamic Range | >94 dB | |
Output Level (nominal) | 1.9 Volts R.M.S. | |
Power Supply | AC 120/230V, 60/50 Hz | |
Dimensions | 8.38” x 8.86” x 3.75” (213 x 225 x 95 mm) | |
Weight | 4.5 lbs. (2 kg) |
*Specifications and design are subject to change without notice for purpose of improvement.
Page 4