Genelec Using the 8240A and 8250A in STAND-ALONE Mode, Connections, Mains Input connector

USING THE 8240A AND 8250A IN STAND-ALONE MODE

The 8240A and 8250A accept both analogue line level input signals and AES/EBU formatted digital input signals.

When the 8240A and 8250A are not connected to Genelec loudspeaker control network, they operate in the stand-alone mode. However, settings made with the Genelec Loudspeaker Manager software can be saved into each loudspeaker and applied even when the network is disconnected by setting switch 1 “STORED/MANUAL CONTROL” on switch group 2 of each loudspeaker to position “STORED.”

This manual concentrates on using the 8240A and 8250A without the control network. All issues concerning use with the network are explained in detail in the System Operating Manual provided with the GLM™ Loudspeaker Manager software kit.

Connections

Each loudspeaker is supplied with a mains cable, one 5 m GLM network cable and an operating manual. Before connecting up, ensure that the mains switch is off.

“MAINS INPUT” connector

Connect the mains supply to this connector.

5