Generac 1019-3 owner manual Assembly, Remove Generator From Carton, Install Wheel Kit

ASSEMBLY

Your generator requires some assembly and is ready for

use at_er it has been properly serviced with the recommended oil and fuel.

If you have any problems with the assembly of your

generator, please call the generator helpllne at 1-800-270-1408.

IMPORTANT:Any a_empt to run the unit before it hzs been serviced with the recommended oil will result in an

engine failure.

Remove Generator From Carton

I, Set _rton on a rigid flat surface with "This Side Up" arrows pointing upward.

2.Carefully open top flaps of shipping car_on. Review "Cold Weather Operation" on pzge 10.

3.Cut down corners at one end of _rton from top to bo_om and lay that side of _rton down tla=

4.Remove all pacl(Tngmaterial, car_on fillers, etc.

S.Remove the generator from the shipping carton.

IIvv

Install Wheel Kit

The wheel Idt is designed to greatly improve the por_bili_ of your generator.

NOTE:Wheel kit is not intended for over-the-road use. You will need a socket wrench with I/2" or 13ram socl(ets and a needle-nose plier to instil this kit,

Refer to Figure I and install the wheel kit as follows:

I.Place the bo_om of the generator cradle on a flat, even surface.Temporarily place unit on bloc_ to e_se assembly.

2.Slide zxle through both axle mounting brackets on cradle frame, as shown in Figure I.

3.Slide a wheel over the axle.

NOTE: Be sure to install both wheels with the air

pressure valve on the outboard side.

4.Place the e-ringonto the groove in the axle.You may add the flat washer if desired.

NOTE: Use retaining pins instead of e-clip, if appli_ble.

5.Place one end of the needle nose pliers on the bot_m of the axle and the other end of the pliers on top of the e-ring. Seat the e-ring by pressing the pliers closed.

6.Repeat step 3 through 5 to secure second wheel.