Generac 1019-3 owner manual Before Starting The Engine, Battery Wire, Add Engine Oil and Fuel

7.Removetie _emporary blocks.

8.At_ch the vibration mourns to the support leg with

30ram capscrews, washers and lock nuts,

9, With the wheels on, you can now Hft up the handle end and a_ch tie suppor_ leg wTth 20ram cap screws

and lock nuts.

IO, Check tiatallfastenersarerightznd thetiresare Tnfla_d

_o tile value marked on tile tTre or wTthin IS and 40 psT.

Check Battery /Attach Negative

Battery Wire

The sealed battery on the generator is fully charged and pre-Tns_lled except for the negative (blacl_) battery cable,

To install;

I.Cut off _ie wrap securing loose end of negative (black) c_ble.

2, Remove nut and washer on negative bakery terminal,

3, Slide negative battery cable over screw on negative _erminal (Figure 2),

Negative
battery	\_
c_ble	Screw
	Positive battery cable

_t. Re_ch wzsher and nut and tighten,

5.Verify tiat connections to bakery and generator are _Jght and secure,

BEFORE STARTING THE

ENGINE

Add Engine Oil and Fuel

•Place generator on a level surface.

•Refer to engfne owner's manual and follow ofl and fuel recommendations and instructions,

CAUTION

NOTE: Checl_ oil often during engine break-in, Refer to engine owner's manual for recommendations,

NOTE: The generator zssembly rotates on a prelubricated and sealed ball bearing that recIuires no additional lubrication for the life of tie bearing,