Generac 7500 owner manual Know Your Generator

GeneracPortableProducts7500EXLExtendedLifeGenerator

KNOW YOUR GENERATOR

Read this owner's manual and safety rules before operating your generator.

Compare the illustrations with your generator to familiarize yourself with the locations of various controls and adjustments. Save this manual for future reference

Circuit Breakers (AC)		Electric Start	Button
12 Volt DC		Recoil	Starter
Receptacle
Idle Control Switch		Choke		Lever
120 Volt AC,		Run/Stop		Switch
30 Amp Locking
Receptacle
		Spark Arrestor Muffler
	/
120/240 Volt AC, 30 Amp	/
Locking Receptacle	/
		240 Volt AC, 50 Amp
120 Volt AC, 20 Amp		Receptacle
Receptacles	Grounding	Wing Nut

12 Volt DC Receptacle i Use this receptacle with battery charge cables to charge a 12 Volt battery.

120 Volt AC, 20 Amp Receptacles May be used to supply electrical power for the operation of 120 Volt

AC, single phase, 60 Hz electrical lighting, appliance, tool and motor loads.

120 Volt AC, 30 Amp Locking Receptacle i May be used to supply electrical power for the operation of

120 Volt AC, 30 Amp, single phase, 60 Hz electrical lighting, appliance, tool and motor loads.

120/240 Volt AC, 30 Amp Locking Receptacle --May be used to supply electrical power for the operation of 120 and/or 240 Volt AC, 30 Amp, single

phase, 60 Hz electrical lighting, appliance, tool and motor loads.

240 Volt AC, 50 Amp Receptacle i May be used to supply electrical power for the operation of 240 Volt AC, 50 Amp, single phase, 60 Hz electrical loads.

Choke Lever Used when starting a cold engine.

Circuit Breakers (AC) -- Each receptacle is provided with a "push to reset" circuit breaker to protect the generator against electrical overload.

Electric Start Switch -- Pressed to start the engine.

Grounding Wing Nut -- Use this connection to properly ground the generator.

Idle Control Switch -- The idle control runs the engine at normal (high) speeds when there is a load present and runs the engine at idle (low) speeds when a load is not present.

Recoil Starter = Used as an alternate means of starting the engine.

Run/Stop Switch -- Must be in "Run" position to start engine. Set to "Stop" to stop a running engine.

Spark Arrestor Muffler-- Exhaust muffler lowers engine noise and is equipped with a spark arrestor screen.

/

4