Generac 7500 Remove Generator, From Carton, Installing Tray And Battery, Carton Contents

GeneracPortableProducts7500EXLExtendedLifeGenerator

Yourgeneratorrequiressomeassemblyandis ready foruseafterit hasbeenproperlyservicedwiththe recommendedoilandfuel.

If you have any problems with the assembly of

your generator, please call the generator helpline at 1-800-270-1408.

IMPORTANT: Any attempt to run the unit before it has been serviced with the recommended oil will result in

an engine failure.

REMOVE GENERATOR

FROM CARTON

INSTALLING TRAY AND BATTERY

You must purchase and install a 12 Volt DC battery (Series U1-109). The battery should be serviced with electrolyte fluid and fully charged prior to installation. Install the battery as follows:

•Find the battery tray and fasteners shipped loose in

the carton. The battery bracket, two 7" J-bolts, two lock washers and two hex nuts are included.

•Remove the four battery tray screws from base.

•Position the battery tray and install (Figure 2).

•	Set the carton on a rigid flat surface with "This Side	I
	Up" arrows pointing upward.
• Carefully open the top flaps of the shipping carton.
	Review "Cold Weather Operation" on page 9.
• Cut down corners at one end of carton from top to
	bottom and lay that side of carton down flat.
• Remove all packing material, carton fillers, etc.		J
•	Remove the generator from the shipping carton.	J

CARTON CONTENTS

Check alt contents If any parts are missing or damaged, call the generator helpline at

1-800-270-1408.

•The generator

Electric start battery cables

Generator and engine owner's manuals Locking 20 Amp and 30 Amp plugs Battery charge cables

Battery tray mounting bracket/hardware Spare spark plug and air filter element Spark plug wrench

•Set battery onto tray and attach bracket, J-bolts, lock washers, flat washers, and hex nuts (Figure 3). Tighten hardware with 3/8" wrench.

/

5