~ÄëçäìíÉ=ÑáÇÉäáíó
all crates and store them safely, in case you need to move these speakers some time in the future.
Next, set up the midrange/tweeter wings. The wings are marked left and right, so set them up on the correct side. First locate the crate containing the left wings, and locate the corresponding Corian panel. The left Corian panel will have the column of tweeters to the right of the midrange ribbon.
Unscrew the top of crates and remove the lids. First, remove the Corian panel with the tweeters and midrange and insert it into the center part of the base. Have someone hold the panel in place until the wings are put in place. The wings hold the panel up, and if the panel tilts too far front or back, the bottom might break off.
Then, while someone else holds the panel vertical,
place one of the veneer/mdf wings into the slot beside the panel. Once both wings are in place, screw the three parts together. Make sure that the tweeters are on the inside – ie. the row of tweeters are closer together than the midrange ribbons.
Insert all 12 screws provided (with the washers) from the back through the holes in the wings into the inserts on the Corian panel.
Once all 12 screws are in, you can then tighten them to make the surface of the wings flush with the Corian panel. Do not
hold the wings and panel vertically in place. The curve of the wings provides most of the structural strength.
Ver 2.0 | 7 |
|
