English
OPERATION
WARNING: To reduce the risk of serious personal injuries, read and follow all important safety warning and instructions before using this tool.
NOTE: Always Check that the power supply corresponds to the voltage on the ratings plate.
Charging the tool (FIG 2)
•Use only the Battery Charger that is included in this kit to recharge your batteries.
•Use only 120 Volt AC Power Source.
•Charge your batteries fully before using the drill for the first time.
•Connect the wall adaptor (2) to charger stand (3)
•Plug the wall adaptor (1) into a 120 Volt AC Power Source. The red light on the charger will illuminate, indicating the charger is power on.
•Insert the battery (1) into the slot on the charger stand
(3). Make sure that the battery is seated firmly in the charger. The green light on the charger will illuminate, indicating that the battery is charging.
•Charge for 3 hours before initial use, and after normal use. If drill has been used continuously, and the battery is completely discharged, it may require up to 5 hours to fully recharge the battery.
3
1 | 2 | FIG 2 |
|
•The green and red lights will remain lit, even after charging is complete.
•Batteries may become warm while charging. This is normal.
•If battery is hot after continuous use in the drill, allow it to cool down to room temperature before charging. This will extend the life of your batteries.
•Other tips for extending battery life: Do not store batteries completely discharged. Charge them fully before storing, and if drill is not used for a long time, take the batteries out and charge them periodically.
WARNING: Always disconnect battery pack from tool or place the switch in the locked or off position before any assembly, adjustments or changing
accessories.
WARNING: Always be sure that the tool is switched off before insertion or removal of the battery pack.
Installing or Removing the Battery Pack (FIG 3) |
| |
FIG 3 | ||
• To install the battery pack, insert the battery pack into | ||
| ||
drill housing as shown in FIG 3. Always insert it all the |
| |
way until it locks in place with a little click. Lightly pull on |
| |
the battery to ensure it is locked into place and will not |
| |
accidentally fall out of the drill, causing an injury. |
| |
• Do not use force when inserting the battery pack. If the | 1 | |
battery does not slide in easily, it is not being inserted | ||
| ||
correctly. |
| |
• To remove the battery pack, withdraw it from the tool |
| |
while depressing the tabs (1) on both sides of the battery |
| |
pack. |
|
18V Cordless Drill/Driver |
|
Operator’s Manual | GCD18BK |
