THE OPENER WILL NOT OPERATE
`BECAUSE OF A POWER FAILURE
OPENER IS NOISY
OPENER RUNS BY ITSELF
REMOTE CONTROL WILL NOT
OPERATE ATA DISTANCE FROM
THE OPENER.
OPENER CLOSES,BUT DOES NOT
OPEN WITH THE REMOTE
OPENER DOES NOT OPERATE
FROM THE REMOTE,BUT DOES
WITH THE WALL CONTROL
OPENER DOES NOT OPERATE
FROM THE WALL CONTROL,BUT
DOES FROM THE REMOTE
THE DOOR STARTSTO CLOSE BUT
REVERSES BEFORE FULLYCLOSING
OPENER LIGHTS STAYON
For Help,call 1-800-35-GENIE or visit www.geniecompany.com 15
AExamine all remotes programmed into the opener. Check for
items that might be pressing on a remote button.Look for remotes
stuffed between seat cushions of the car.
BIf a remote has been lost or stolen,erase the opener’s memory
to prevent the missing remote from activating the opener.
Reprogram the remaining remotes into the opener.
CCheck the wiring between the wall control and the opener.Look
for staples that have cut into the wire’s insulation,or wire that has
been pinched by a object.Replace any bad wire.
DExamine the wiring at the opener’s terminals and the wall
control terminals.Look for any wires that are close to or touching
adjacent terminals.
Trouble 13:
ABe sure that the opener’s antenna (the short white wire on the
back of the opener) is extended upward from the opener.
BCheck the remote’s battery.
CRemote control operating distance will vary depending on the
amount of interference and metal obstacles in the path of the signal.
Trouble 12:
ALubricate the door hardware as recommended by the garage
door manufacturer.
Trouble 14:
APull the carriage release handle to disengage the opener from
the door.The door can be operated manually until power is restored.
Trouble 15:
AIf the opener light flashes 4 times,the close door force setting may
be too low.
BThe door hardware may be binding causing the door force setting
to be exceeded.Disengage the carriage and manually check the door
movement and balance.Lubricate the door hardware as recommended
by the manufacturer.
CThe Safe-T-Beam® has been interrupted while the door is closing
(opener light flashes 3 times),or the Safe-T-Beam® is out of alignment.
Trouble 7:
AIt is normal for the lights to stay on for about 5 minutes
after being activated.
BIf the lights were turned on using the light button on the
wall control,they will stay on until they are turned off using
the wall control light button or the door is cycled open or
shut.
Trouble 8:
ACheck the wall control wiring at the wall control and
opener terminals.
BCheck the wiring between the wall control and the
opener.Look for any staples that have cut into the wire’s
insulation or wire that has been pinched.If the opener light
flashes 2 times when the remote is used,the wall control
wires are shorted and the bad section must be replaced.
Trouble 9:
ABe sure that the remote is programmed into the opener.
BCheck the remote’s battery.The red light should light up
when ever the remote button is pressed.
Trouble 10:
AIf the opener lights flash 5 times when the remote is
activated,and the door does not open, the vacation
switch is on.Turn the vacation switch off
(optional accessory).
Trouble 11: