Genie 3563435770, 2040L Flashlight, Erasing all remotes Figure, Program receiver again as needed

Flashlight Button

Press Button again. Garage door will reverse.

Some Remote Controls are equipped with a flashlight. The Genie logo is the button which operates the light. There is a backlight under the button. When it does not light, it indicates the battery needs replaced.

•

•

C Remote Control Operation.

• Press Button on Remote Control. Garage door will move.

• Press Button again. Garage door will stop:

The door automatically stops at the end of the open or close cycle.

Frequency

Switch

1 Button	3 Button	3 Button
Remote	Remote	Large
w/Flashlight	w/Flashlight	Remote
		w/Flashlight

Figure 3 Genie Remote Controls

NOTE

•Each Remote Control must be programmed separately.

•The Remote Controls will not cause the door Opener to close the garage door if the Safe-T-Beam® System is malfunctioning.

•When Programming the Remote Controls, they must be at least 24”from the Antenna Wire.

•If the red Learn Indicator Light blinks approximately 4 times per second, programming has stopped, repeat the above steps.

•Each Button on a 2 or 3 Button Remote Control is for a different Opener. You cannot use more than one Button per Remote, per Opener.

•A maximum of seven Remote Controls or Wireless Keypads can be stored into the Receiver at one time. If a Remote Control becomes lost, or if you want to delete a Remote Control or Wireless keypad, see “To Erase all Receiver Memory”

CAUTION

Should a remote become lost or stolen it is imperative that the remote control codes be erased from the receiver memory and new codes programmed,to prevent the missing remote from being able to operate the door opener.

DErasing all remotes (Figure 4).

•Press and hold Learn Button on Power Head until Learn Indicator Light goes out. Memory is erased.

•Program receiver again as needed.

For Help, call 1-800-35-GENIE or visit www.geniecompany.com

AND GO OUT

Figure 4 Erasing the remotes

NOTE

If the light on the remote glows dimly or does not light when operating the remote, replace the batteries.

EReplacing the batteries.

•Pop off the back of the transmitter using a coin.

•Replace the battery with a new compatable coin type battery. (size 2032)

•Snap the back of the transmitter on.

Transmitter Compliance Statement

9