Genie 3024 All optional programming is complete. Your garage door opener is ready to use.

©2010 The Genie Company 01/27/2010 9
PROGRAM
SET
—+
5 SECS
PROGRAM
SET
—+
PRESS and HOLD
SEE BOTH
Blue LEDs
come ON
SEE one
Blue LED
come ON
PRESS a previously programmed Genie® IntelliCode® 2 remote button on remote. If you are unsure which remote you have see page 15. Remote must be IntelliCode® 2 enabled.
RELEASE
1 2 3 4
OPTIONAL PROGRAMMING POWER HEAD TO
Homelink®, Car2U®, or IntelliCode® 1 REMOTES and SERIES II WIRELESS KEYPADS
To complete any of these tasks you MUST have at least one Genie® IntelliCode® 2 remote button already
programmed to the power head. Homelink® or Car2U®: You must also have your Homelink® or Car2U® enabled vehicle present and their programming instructions to perform these programming steps. Genie® remote: You must also have your Genie® IntelliCode® 1 remote present. Genie® wireless keypad: You must also have your Genie® wireless keypad installed and a PIN already programmed into the keypad.
PRESS and
RELEASE
5On the IntelliCode® 1 remote PRESS
a button and RELEASE.
6SEE both LEDs flash Blue.
IntelliCode® 1 remote or wireless keypad programming
7On the IntelliCode® 1 remote PRESS
the same button and RELEASE. The next press of the remote will operate door.
5Enter your wireless keypad PIN.
6Press and hold button
(3 seconds) on wireless keypad and see on power head long LED come ON Purple. (You may have to press
more than once.)
8Test. Repeat as necessary for any
other IntelliCode® 1 remotes.
7Press and hold button
(3 seconds) on wireless keypad again and see on power head both LEDs come ON Blue.
8Wait 30 seconds and test operation.
Genie® IntelliCode® 1 remote Genie® IntelliCode® 1 wireless keypad
SEE long Purple
LED flashing
SEE both LEDs flash Purple
All optional programming is complete. Your garage door opener is ready to use.
5For Car2U® enabled vehicles follow the Car2U®
instructions.
6Test. Repeat as necessary for any other Car2U®
enabled vehicle.
Homelink® or Car2U® programming If your Homelink® has been previously programmed to an Genie® opener begin with Step 5. If your Homelink® has not yet been linked to a Genie® opener then go to page 15 and change one remote button from IntelliCode® 2 to IntelliCode® 1, then program that button to the power head and repeat steps 1-4 then continue with Homelink® steps 5-6.
5 6
PRESS the Homelink® button twice. Test. Repeat as necessary for any other pre- programmed Homelink® enabled vehicle.