CO1209 SERIES

 

 

 

CO1209 SERIES

 

 

 

 

 

 

 

 

ELECTROCHEMICAL CARBON

 

 

 

 

MONOXIDE (CO) ALARM

 

 

 

ELECTROCHEMICAL TYPE SINGLE/MULTIPLE STATION

 

 

 

CARBON MONOXIDE ALARM, AC POWERED, WITH BATTERY BACK-UP

 

 

 

& TANDEM WIRE CONNECTION

 

 

Installation Instructions - Owner's/User’s Information Manual -READ CAREFULLY AND SAVE

 

 

 

INTRODUCTION CO1209 SERIES

quiet the alarm horn. If critical levels of CO remain, the alarm will

 

 

The CO1209 electrochemical carbon monoxide (CO) alarm is for

re-activate and sound.

use as an evacuation device in all dwelling units. The device has a

NOTICE: MALFUNCTION WARNING This unit performs a self-

solid state piezo signal to warn and alert the occupants to the

diagnostic test. If the alarm malfunctions it should be replaced

presence of carbon monoxide.

immediately. See IF THE CO ALARM IS NOT OPERATING

 

 

Your CO alarm is designed to detect abnormal amounts of

PROPERLY for more information.

carbon monoxide gas, only. Consequently, it is uncommon for

HOW TO TELL IF THE CO ALARM IS WORKING

household sources of combustion, including properly functioning

household appliances, to produce sufficient levels of CO to cause an

PROPERLY

alarm.

￿ Your device is provided with an alarm horn and flashing red Light

BASIC SAFETY INFORMATION

Emitting Diode (LED) indicator, which flashes every 15-30

 

 

Dangers, Warnings, Cautions and notices alert you to important

seconds, and a green AC power on LED and red LED for CO.

operating procedures or to potentially hazardous situations. Pay

WHAT YOU CAN DO TO MAKE YOUR FAMILYSAFE

special attention to these items.

FROM CARBON MONOXIDE (CO)

WARNING!

a. Install CO alarms properly following the instructions in

￿ This CO alarm is listed for use in single-family and multi-family

this manual. Keep your units clean. Test your CO alarm

 

 

residences, along with hotel, motels and other dwelling units.

weekly and replace when it no longer functions.

￿ This CO alarm will only indicate the presence of increased levels

As with any electronic product, CO alarms have a limited life,

 

 

of carbon monoxide gas at the sensor. Increased levels of carbon

it is recommended that CO alarms be replaced every five (5)

 

 

monoxide gas may be present in other areas.

years. CO alarms that don't work cannot protect you.

￿ This CO alarm must receive continuous 120VAC, 60Hz , pure

b. Develop a family escape plan and practice it with your

 

 

sine wave electrical power. (battery is meant for emergency

entire family, especially small children.

 

 

back-up only). In order for the emergency battery back-up to work,

￿ Draw and post a floor plan of your home and find ways to

 

 

a new battery must be properly installed (see BATTERY

exit from each room.

 

 

INSTALLATIONsection).

￿ Teach children what the CO alarm signal means, and that

￿ NEVER ignore your CO alarm if it sounds. Refer to IF YOUR CO

they must be prepared to leave the residence by themselves

 

 

ALARM SOUNDS section for more information. Failure to do so

if necessary.

 

 

can result in serious injury or death.

￿ Decide on a meeting place a safe distance from your house and

￿ Test this device once a week. If the device ever fails to test

make sure that all your children understand that they should go

 

 

correctly, replace immediately! If the device is not working

and wait for you if there is a CO alarm.

 

 

properly, it can not alert you to a problem.

￿ Hold CO drills at least every 6 months to make sure that

￿ This product is intended for use in indoor locations of family

everyone, even small children, know what to do to escape

 

 

dwelling units. It is not designed to measure CO levels in

safely.

 

 

compliance with Occupational Safety and Health Administration

￿ Know where to go to call the fire department from outside your

 

 

(OSHA) commercial or industrial standards. Individuals with

residence.

 

 

medical conditions that may make them more sensitive to carbon

WHAT TO DO IF THERE IS A CO EMERGENCY IN

 

 

monoxide may consider using warning devices which provide

 

 

audible and visual signals for carbon monoxide concentrations

YOUR HOME

 

 

under 30 ppm. For additional information on carbon monoxide and

If you have prepared family escape plans and practiced them with

 

 

your medical condition, contact your physician.

your family, you have increased their chances of escaping safely.

 

 

Review the following rules with your children when you have CO

MODELS

drills so everyone will remember them in a real CO emergency. If

alarm should sound:

(SEE BACK OF CO ALARM FOR EXACT MODEL)

a. Don't panic; stay calm. Your safe escape may depend on thinking

CO1209..........................120VAC, 60Hz

clearly and remembering what you have practiced.

CO1209F........................120VAC,60Hz with Form A/Form C auxilary

b. Open windows or doors. Opening windows or doors can

relay contact

significantly reduce CO levels.

NOTICE: In the event AC Power fails, a 9VDC battery will provide

c. Get out of the house following a planned escape route as quickly

as possible. Do not stop to collect anything or to get dressed.

proper alarm operation for a minimum of 24 hours.

d. Meet at your prearranged meeting place after leaving the house.

HOW THE CO ALARM WORKS

e. Call the Fire Department as soon as possible from outside your

GENERAL INFORMATION

house. Give the address and your name.

NOTICE: CO problems can occur at any time.

f. Never re-enter the building while the device is in alarm.

 

 

When fully powered, the device samples the air and takes a new

Contact your local Fire Department for more information on

reading about every 30 seconds. A microchip inside the unit stores

making your home safer from CO and about preparing your family's

each reading and remembers the levels of CO it has been exposed

escape plans.

to over time. The CO alarm will sound when it has been exposed to

NOTE: Current studies have shown CO alarms may

a critical level of CO (measured in parts per million or ppm) within a

specified time (measured in minutes). This CO alarm features a

not awaken all sleeping individuals, and that it is

permanently installed sensor, an indicator light and an 85dBA,

the responsibility of individuals in the household

temporal 4 alarm horn. It also has a reset feature to temporarily

 

 

550-0498 Pg. C-1

Page 1
Image 1
Gentek installation instructions CO1209 SERIES, Electrochemical Carbon, Monoxide Co Alarm, Tandem Wire Connection