3. The indicator signal chart:
Sound and LED indicator:
|
| Red LED |
| Power on |
| |
|
|
|
|
|
|
|
|
| Green LED |
| Relay activated |
| |
LED signal |
|
|
|
|
|
|
|
| Entering the Program mode |
| |||
|
|
|
|
|
|
|
|
|
| Slot position is registered |
| ||
|
|
|
|
|
|
|
|
|
| Slot position is ready to register |
| ||
|
|
|
|
|
|
|
|
| 1 Beep |
| Slot position is ready to register 、Effective | card （PIN | |
|
|
| codes）、Exit from the Program mode |
| ||
|
|
|
|
| ||
Sound signal |
| 2 Beeps |
| Entering the Program mode |
| |
|
|
|
|
|
| |
| 3 Beeps |
| Slot position is registered 、Data computing error 、 other | |||
|
|
| ||||
|
|
| operation mistakes、 duplicate card |
| ||
|
|
|
|
| ||
|
| 5 Beeps |
| Master Code reset to Factory （12345） |
| |
|
|
|
|
|
| |
Factory Parameter list： |
|
|
|
| ||
|
|
|
| Format | 26 bits |
|
|
|
|
|
| ||
|
| Card register | None |
| ||
|
|
|
|
| ||
|
| Master Codes | 12345 (5 digits) |
| ||
|
|
|
|
|
| |
|
|
| Strike Time | 1 seconds |
| |
|
|
|
| |||
| Pressed key delay time (Time Out) | 5 seconds |
| |||
|
|
|
|
| ||
|
| Program mode delay time | 60 seconds |
| ||
|
|
|
|
| ||
|
| Invalid PIN | 60 seconds |
| ||
|
|
|
|
|
|
|
4. Operation Instruction:
Enter Program Mode:
1.Compose twice the master code (Factory master is 「12345」)
→2 beeps and the Yellow LED will light up
→you are now in the "programming mode".
2.Note: After 60 seconds if you have not entered any codes or data, the system will automatically exit from the programming mode. After 6 wrong attempts at the master code the lockout facility will operate.
Exiting from the program mode:
1.Press「#」 to exit from the programming mode.
2.Note: After 60 seconds if you have not entered any codes or data, the system will automatically exit from the programming mode. After 6 wrong attempts at the master code the lockout facility will operate.
Selecting The User Format
Enter the Programming mode, Press「＊30」
Followed By「01」：This will set the system to be used as :Wiegand
001~100 for cards/tokens and slots 01~150 for PIN codes
OR
Followed By 「02」：This will set the system to be used as : Wiegand
001~100 for cards/tokens and slots 01~150 for PIN codes
OR
Copyright Gianni Industries, Inc. All Rights Reserved. |
|
Page: 2/ 4 |
