Product Characteristic | Gianni Industries DG-30

Operation User's Manual

1. Product Characteristic:

Allows up to 150 Proximity cards / tokens or PIN codes Tamper Switch Included

Door Reed Switch Input for Anti-Trailing

Fully Programmable via keypad and master code

Extendable from keypad only to proximity controller Supports 26 or 34-bit Wiegand auxiliary reader

Logical memory to prevent duplication Non-Volatile Memory

Invalid PIN Lock-out

Operating Voltage: 12 Vdc

Current Draw:

60mA Max @12VDC

Input: request-to-exit, time out reed switch contact, auxiliary reader

Relays Electric Current: 2A MAX @30Vdc ；0.4A @ 120Vac

Memory Volume: 150 PIN codes or 100 Proximity cards/tokens and 50 PIN codes

Format: 26 or 34-bit Wiegand hexadecimal.

Relay 1 is controlled by 001~100 user slots（Cards or PIN codes）

Relay 2 is controlled by 101~150 user slots（PIN codes）

PIN codes: 5 digit codes only

Case Material: ABS （UL94V0）

Operating Temperature: -20~+70℃

Ambient Humidity: 5~95% relative humidity non-condensing

Visual Signals:

Red: Power on

Green: Relay activated

Tri-color LED:

Yellow: Program Mode

Red: The slot is registered、Lock-out

Green: This slot may register the card or PIN codes.

Factory Master Code: 12345

Invalid PIN Lock-out: The system will shut down for 60 seconds while 32 codes of incorrectly Master Codes enrolled or PIN codes attempted.

EPROM: Non-volatile memory, System will retain all programs and codes after a total loss of power.

Output: Dual relay, N.O./N.C./Com. Output (free voltage contact) 、Tamper switch

Relay Activation Time: （＊10、＊20）

Strike Time: 1~99 seconds（adjustable）

Strike mode: Access Timer or Latch

Color: Dark gray/ Beige White

Copyright Gianni Industries, Inc. All Rights Reserved.
P-MU-DG30 Ver. A Publish:2004.08.26	Page: 1/ 4