Operation Instruction
The Master Code is set to 1234 as factory default.
Enter Programming Mode
Compose twice the master code (Factory master is 「1234」)
→an audible and the LED will flash red → you are now in the "programming mode".
Exiting from the program mode
Press「#」 to exit from the programming mode.
The system will out of the programming
Change the Master code
Enter the Programming mode, Enter the slot position code 「 ＊00」 → Enter the new master code 「????」the long beep sound heard → The new Master code is set.
Full Color Villa Video Door Phone
Setting the relocking timer
Factory default set is 0.5 second.
Enter the Programming mode → Enter 「 ＊99」 → Enter the desired lock / relay operation time in a two digit format (01~99 seconds) → Press 「 #」 t o e x i t f r o m t h e p r o g r a m m i n g m o d e , o r programming other operating. The lockout facility will operate.
Master Code reset to Factory 「1234」
Remove power from the unit and hold down the「 ＊ 」key. → Apply power whilst holding button down, the unit will then give long continuous tone. When the tone has stopped, → Press 「＊00#」→ The Master code reset to Factory 「1234」.
Add PIN codes
Enter the Programming mode, Enter the slot position code 「 ＊01~40」 →???? Input 4 digit PIN codes→ (beep) enrolled. Press 「 #」 to exit from the programming mode, or program other operating.
Note : The codes「0000」,「1234」or master code are not be used for PIN code.
Delete a PIN Code
Enter the Programming mode→ Press the slot position code of your choice to delete (example "06") → Press「 ＊ 06」 →
「0000」 (beep)→ delete→ Press「 #」 to exit from the programming mode, or programming other operating.
Delete all PIN Codes
Enter the Programming mode→ Press 「 ＊88」(The red LED will remain on.) → Press「 0000」 (The red LED turn off, beep)→Indicate that the delete all PIN codes.
GIANNI INDUSTRIES, INC.
No. 13, Zhong Sing Road,
Tel:
Website: gianni.tw
Care and maintenance
1.Do not put the outdoor sation near the magnetic area such as televison, video recorder etc.
2.Do not drop, knock or shake the unit.
3. Do not put the outdoor sation in hot areas, high temperatures can shorted the life of electronic device.
4.Do not attempt to open the unit, non expert handing may damage the unit.
5.Keep the indoor monitor dry, humidity and all types of liquids or moisture contains mineral that will corrode electronic circuits.
6.Do not use the wet dishcloth or the volatile cleansers to clean it.
7.The installation position of outdoor station and indoor monitor should be about 150 cm height.
8.Power must be shut off when installing.
Warranty
The product is warranted against defects in material and workmanship while used in normal service for a period of 1 year from the date of sale to the original customer. The GEM policy is one of continual development and improvement; therefore GEM reserves the right to change specifications without notice.
The products are manufactured under an ISO 9 0 0 1 & Q C 0 8 0 0 0 0 C e r t i f i e d Q u a l i t y Management Program environment back its product quality, performance and commitment to customer satisfaction.
Copyright 2008 Gianni industries, inc. All rights reserved.
