INSTALLATION
STEP 1 : PREPARE INSTALLATION
Do not lift the appliance by the door handle.
Whilst every care is taken to elimi- nate burrs and raw edges from this product,please take care when handling
-we recommend the use of protective gloves during installation.
Please note that the weight of this appliance is approximately 31kg (unpacked). Take care when lifting it into the housing unit - always use an appropriate method of lifting.
Remove the fixing screws from the
polythene bag on the top of the appli- ance, but leave the appliance in the base tray packaging until you are ready to install it.
If this appliance is to be installed near to a corner where the adjacent cabinets run at right angles forward of the appliance, there must be a gap of at least 90 mm between the appliance and the cabinets, to prevent overheating of the cabinets.
Housing dimensions
The appliance is designed to fit into a
standard 600mm wide housing unit with minimum internal dimensions as shown. 590mm is to the underside of the worktop
when the appliance is built under, or to the underside of the panel above, when the appliance is installed into a tall
