INSTALLATION - 70CM
Method 3: Housing unit with internal height 710mm or more
Note: You will not need the 4 runners and 2 trims that are packed with the oven for this installation.
1.When installed in a typical 600mm deep built in housing unit, the false back should be removed from the housing unit to provide the necessary depth for
installation.
2.When the false back is removed, it is normally the case that the support shelf for the appliance leaves a gap between the back edge and the wall of approxi- mately 80mm.
3.If no gap occurs between the back edge of the shelf and the wall behind the unit, you must create a gap of at least 30mm by shortening the shelf.
Remove any fixings that may prevent
entry of the oven into housing, or
obstruct the gas inlet pipe. The cabinetry should be kept structurally sound by
