Unpacking
Due to modern mass production techniques, it is unlikely that your GMC Power Tool is faulty or that a part is missing. If you find anything wrong, do not operate the tool until the parts have been replaced or the fault has been rectified. Failure to do so could result in serious personal injury.
Assembly
Wheels
Fitting the wheels
Note. In order to fit the wheels the following supplied accessories are required:
Washer
Nut
Bracket
Wheel bolt | Wheel |
|
|
|
1.To fit the wheels (12) first insert the wheel bolt through the wheel.
2.Fit the wheel assembly through the hole in the bracket under the tank.
3.Select one of the provided washers and nuts.
Slide the washer onto the wheel bolt then proceed to screw on the nut.
4.Completely tighten the nut from the underside of the wheel with spanner while holding the outer side nut with another spanner.
5.Repeat for the second wheel.
Handle
The handle of the compressor must be fitted in the following manner:
Note. In order to fit the handle the following supplied accessories are required:
1.Insert the handle into the inside walls on the brackets which have been welded onto the tank.
2.Align the holes of the handle and the bracket.
3.Select one of the hex head bolts and one washers depicted above.
Slide the washer under the head of the hex head bolt and insert the assembly into one of the fixing holes.
Note. Make sure that the bolt slots through both the handle and the welded bracket holes.
4.Using your hands fit the nut to the threaded end of the bolt. Screw together until it is hand tight.
5.Repeat the above process for the remaining three holes.
6.Once all four bolts have been hand tighten select the provided Allen key and a spanner or socket and go over the four bolts, ensuring that they are tightly secured.
9
