b. Do not use the power tool if the switch does not turn
it on and off. Any power tool that cannot be controlled with the switch is dangerous and must be repaired.
c. Disconnect the plug from the power source before making any adjustments, changing accessories, or storing power tools. Such preventive safety measures reduce the risk of starting the power tool accidentally.
d. Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool.
Power tools are dangerous in the hands of untrained users.
e. Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tools operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools.
f. Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control.
g. Use the power tool, accessories and tool bits etc., in accordance with these instructions and in the manner intended for the particular type of power tool, taking into account the working conditions and the work to be performed. Use of the power tool for operations different from those intended could result in a hazardous situation.
5. Service
a. Have your power tool serviced by a qualified repair person using only identical replacement parts. This
will ensure that the safety of the power tool is maintained.
Additional safety rules for angle grinders
•Fully unwind cable drum extensions to avoid potential overheating.
•When an extension cable is required, you must ensure that it has the right ampere rating for your power tool and is in safe electrical condition.
•Always switch off before you put the angle grinder down.
•Do not let anyone under 18 years operate this tool.
•Rags, cloths, cord, string and the like should never be left around the work area.
•If you are interrupted when operating the tool, complete the process and switch off before looking up.
•Periodically check that all nuts, bolts and other fixings are properly tightened.
•Check the disc before mounting it into the angle grinder. Check by striking it with a wooden handle whilst balancing the disc on your finger. Listen for the ring and do not use if dull, as the disc may be cracked.
•When the disc is installed, run it for at least one minute to ensure that it does not have a fault. It is always advisable to stay out of the line of the disc when testing or when using the tool.
•Do not use a disc marked with a lower RPM than that of the no load speed shown on the rating plate.
•Use discs only of the prescribed diameter.
•Do not use the angle grinder for buffing or polishing under any circumstances.
•Never try to operate the angle grinder without the guard in place.
•Do not secure the angle grinder in a vice or work bench and use it as a static grinder. It can lead to serious injury.
•Never apply excessive pressure to the disc. It might shatter causing personal injury.
•Ensure the work piece to be ground or cut, is held tight in the vice or other clamping system.
5
