8.Use safety accessories. Safety glasses and earmuffs should always be worn. A face or dust mask is also required.
9.Connect dust extraction equipment. If devices are provided for the connection of dust extraction and collection facilities, ensure that these are connected and properly used.
10.Do not abuse the power cord. Never pull the cord to disconnect the tool from the power point. Keep the cord away from heat, oil and sharp edges.
11.Secure the work piece. Use clamps or a vice to hold the work piece. It is safer than using your hand and frees both hands to operate the tool.
12.Do not overreach. Keep your footing secure and balanced at all times.
13.Look after your tools. Keep tools clean and sharp for better and safer performance. Follow the instructions regarding lubrication and accessory changes. Inspect tool cords periodically and, if damaged, have them repaired by an authorised service facility. Inspect extension cords periodically and replace them if damaged. Keep tool handles dry, clean and free from oil and grease.
14.Disconnect idle tools. Switch off the power and disconnect the plug from the power point before servicing, when changing accessories and when the tool is not in use.
15.Remove adjusting keys and wrenches. Form the habit of checking to see that keys and adjusting wrenches are removed from the tool before switching it on.
16.Avoid unintentional starting. Always check that the switch is in the OFF position before plugging in the tool to the power supply. Do not carry a plugged in tool with your finger on the switch.
17.Use outdoor rated extension cords. When a tool is used outdoors, use only extension cords that are intended for outdoor use and are so marked.
18.Stay alert. Watch what you are doing. Use common sense. Do not operate a power tool when you
are tired.
19.Check for damaged parts. Before using a tool, check that there are no damaged parts. If a part is slightly damaged, carefully determine if it will operate properly and perform its intended function. Check for alignment of moving parts, binding of moving parts, breakage of parts, proper mounting and any other conditions that may affect the operation of the tool. A part that is damaged should be properly repaired or replaced by an authorised service facility, unless otherwise indicated in this Instruction Manual. Defective switches must be replaced by an authorized service facility. Do not use a tool if the switch does not turn the tool on and off correctly.
20.Guard against electric shock. Prevent body contact with grounded objects such as water pipes, radiators, ranges and refrigerator enclosures.
21.Use only approved parts. When servicing, use only identical replacement parts. Use an authorised service facility to fit replacement parts.
Warning. The use of an accessory or attachment, other than those recommended in this Instruction Manual, may present a risk of personal injury.
5
