Additional safety rules for bench grinders
•Always remove the plug from the mains socket before making any adjustments or maintenance, including changing the wheel.
•Always wear eye protection and check that the eye shields on the grinder are properly adjusted.
•Always turn the grinder off when it is not in use and never leave it unattended without first switching off and removing the power plug. Never leave the grinder until the grinding wheels have come to a complete stop.
•Make sure that any replacement wheel is rated at 3000RPM or higher.
•Do not let anyone under 18 years operate this tool.
•Rags, cloths, cord, string and the like should never be left around the work area.
•If you are interrupted when operating the tool, complete the process and switch off before looking up.
•Periodically check that all nuts, bolts and other fixings are properly tightened.
•Do not use a wheel that has received a blow, especially to the side of the wheel.
•Replace a cracked or suspect wheel.
•Always allow a new wheel to run for a few minutes at full speed before using it. Stand to one side at start up.
•Check that the wheel rotates freely each time before start up.
•Do not use the grinder unless all the guards are properly fitted and secure.
•Check that the tool rests are properly adjusted before commencing use.
•Do not overload the grinder. Allow the grinder to run at full speed, or close to full speed during use.
•Never apply excessive pressure to the wheel. It might shatter causing personal injury.
•Make sure that the wheel is not in contact with the work when you start the grinder.
•When using the grinder, use safety equipment including safety goggles or shield, ear protection, dust mask and protective clothing including safety gloves.
Wear goggles
Wear ear protection
Wear a breathing mask
Unpacking
Due to modern mass production techniques, it is unlikely that your GMC Power Tool is faulty or that a part is missing. If you find anything wrong, do not operate the tool until the parts have been replaced or the fault has been rectified. Failure to do so could result in serious personal injury.
Connecting to the power supply
The GMC Bench Grinders covered in this manual are designed to operate from a standard household supply of
All the grinders are of Class 1 Category (earthed) and are fitted with a
6
