![](/images/new-backgrounds/1315326/31532619x1.webp)
3. | Whilst holding the spindle lock |
| |
K | |||
| button rotate the blade by | ||
|
| ||
| hand until the blade locks in |
| |
| place (fig K). |
| |
4. | Whilst depressing the spindle |
| |
| lock button, turn the blade |
| |
| flange |
| |
| pin wrench provided (fig L). |
| |
5. | Remove the outer blade |
| |
L | |||
| flange (fig M). | ||
|
| ||
6. | Remove the blade from the |
| |
| inner flange. |
| |
7. | Clean the blade flanges |
| |
| thoroughly before mounting |
| |
| the new blade. Wipe a drop |
| |
| of oil onto the inner and outer |
| |
|
| ||
| flange where they will touch |
| |
| M | ||
| the blade. |
8.Mount the new blade onto the spindle and against the inner flange.
9.Replace the outer flange and tighten.
WARNING. The direction in which the blade rotates has to be the same as the direction of
the arrow marked on the housing.
10. Ensure that the spindle lock button is released.
IMPORTANT. After replacing the saw blade, make sure that the saw blade runs freely by turning the blade by hand.
11.Replace the base plate and secure with the 4 screws.
12.Plug the machine into a power socket and run the biscuit joiner under no load to check that it runs smoothly before using it to cut any material.
Turning on and off
1.Connect the plug to the power point.
2.Start the tool by squeezing the on/off trigger switch (fig N).
3.Release the trigger to stop the tool.
4.If you press the
N |
| O |
|
|
|
5.The
6.To release the
10