Forward/reverse switch
This switch (4) will allow you to change the direction of the motor while the trigger switch is not depressed.
Drilling uses the forward mode. The reverse mode is intended for the removal of screws.
Adjustable torque
This drill is equipped with 21 torque settings plus one drill setting which are controlled by the torque collar (2). By rotating the collar behind the chuck, it is possible to adjust the torque.
This will allow better control when using the drill as a screwdriver as it prevents over- tightening of the screws.
For drilling, always use the use the Drill position by aligning the Drill symbol with the triangular indicator on the front face of the drill near the torque collar.
For setting the torque position, select a low setting on the torque collar and align the selected symbol with the triangular indicator on the top of the drill. Increase gradually to set the correct torque. It is better to use a scrap piece of material if possible to set the torque.
Inserting and removing bits
This drill has a keyless chuck, which means that a chuck key is not needed to secure a bit in the drill.
1.Open the chuck by holding the rear section of the chuck firm and rotating the front section in a
2.Ensure the drill bit is fully inserted, so that the chuck
jaws grip the straight section of the bit.
3.Holding the rear section of the chuck firmly, rotate the front section of the chuck
4.To remove the drill bit, hold the rear section of the chuck firmly and rotate sharply the front section of the chuck in a
Adjustable side handle
1.Turn the side handle clamp knob (6)
to loosen the collar fully and slip it over the chuck (1) onto the drill.
2.Adjust the position of the side handle (5) to suit the application and tighten the side handle clamp knob (6) to secure it in place.
12
