1.To fit the extension cord to the support, make a tight loop in the extension cord, approximately 300mm from the socket on the extension cord.
2.Fit the loop into the cord support (6)located on the power cord of the blower/vac.
3.Push the loop all the way through the cord support (6) by approximately 25mm.
Selecting the blowing operation
1.Move the selector lever (2) down. You will hear a loud click as it goes into place.
Note. When the blow operation is selected, air is drawn up through the large blow/vac tube and then expelled at a much higher velocity in the lower cavity below the blow/vac tube.
IMPORTANT. Ensure when the blow operation is selected the blower/vac is pointed, directed and used in a safe manner. Do not direct the air flow from this blower vac directly or indirectly towards another person.
Selecting the vacuum operation
1.Push the selector lever (2) up. You will hear a loud click as it goes into place.
Note. When the vacuum operation is selected, air and debris are drawn up through the large vac tube, and forced through the metal mulching impeller. The debris is mulched
and then blown down into the collection bag.
IMPORTANT. Always ensure the collection bag is correctly attached as per the “Fitting the collection bag” section in this manual.
Important notes when using the blower/ vacuum selector lever
Do not force the lever. The lever should move with very little resistance. If the lever is difficult to move, disconnect the power supply, remove the collection bag and ensure debris, dirt or mud has not jammed the lever.
When selecting either of the operations, ensure the selector lever is fully in one position or the other, not half way.
To empty the collection bag
It is not necessary to remove the collection bag from the blower vac when the bag needs to be emptied.
The rear of the bag is fitted with a full length zip. Simply open the zip and empty the contents.
Ensure to close the zip prior to operating the blower vac.
10
