Preparation of the blower vac prior to use
The BLV8000A blower vac requires some assembly prior to use for the first time. This includes extending of the teloscopic blower vac tube, fitting of the collection bag and fitting of the shoulder strap to the housing.
Extending the telescopic blower vac tube
WARNING. The Blower Vacuum must be fully assembled with the blower tubes fully extended and secured in place before use.
1.Firmly take hold of the blow/vac tube - lower (12b) and extend it out fully until the arrow on the lower tube is clearly visible.
EXTENSION MARK
2.Two screws are supplied for securing the tube in place. With the blow/vac tube
- lower (12b) completely lowered and the arrow visible. Insert the two fixing screws into the holes in the blow/vac tube - upper (12a) and through into the blow/vac tube - lower (12b). Secure tight with a screwdriver
(not supplied).
3.Lightly tap the plastic caps on top of the fixing screws to prevent from tamper.
To fit the collection bag
WARNING. Never operate the vacuum without the collection bag attached.
Note. Always make sure the bag zipper is closed when the unit is in use.
For use as a vacuum, the collection bag (5) must be fitted.
To fit the collection bag, turn the blower vac upside down so the vacuum outlet is exposed.
1.Place the bag connector over the vacuum outlet and push the two collection bag locking clips (13) inwards to secure the collection bag firmly
in place.
2.Fit the top collection bag strap onto the bag retaining clip
- upper (14a) and the lower collection bag strap onto the bag retaining clip - lower (14b).
To remove the collection bag
1.Unhook the collection bag straps from the upper and lower bag retaining clips (14a & 14b).
2.Push the two collection bag locking clips (13) inwards and pull the collection bag out and away from the housing (10) of the blower vacuum.
8
