Upper guide pin adjustment
1.To adjust the guide pins loosen the 2 screws that hold the guide pins in place using the 3mm hex key supplied.
2.Press the guide pins together against the band saw blade.
3.Turn the band saw wheel by hand in a clockwise direction several times to bring the guide pins into the correct position. Both guide pins should just touch the saw blade.
4.Tighten the guide pin locking screws.
CAUTION: Ensure the blade is not pinched by rotating the band saw wheel one or two times by hand.
Lower blade guide adjustment
WARNING. Always ensure that the saw is switched
off and unplugged from the power supply before making any adjustments.
1.The lower blade guide adjustments consist of a thrust bearing that supports the band saw blade from the rear and two guide pins that provide lateral support, these need to be readjusted after every band saw blade change or tracking adjustment.
2.The work table needs to be tilted 45° and the door needs to be open before the thrust bearing locking screw and guide pins can be adjusted. This helps give better access to the adjustment screws.
Thrust bearing adjustment
1.To adjust the thrust bearing loosen the thrust bearing locking screw using the 3mm hex key supplied. It is easier to access the thrust bearing screw if the work table is placed on a 45° angle.
2.Adjust the thrust bearing position until it is 0.5mm away from the band saw blade. When the band saw blade
is turned by hand it should not make contact with the thrust bearing.
3.Tighten the thrust bearing locking screw.
Lower guide pin adjustment
1.With the table set to 90° adjust the guide pins by loosening the 2 screws that hold the guide pins in place using the 3mm hex key supplied. The lower housing door needs to be opened to access the screws.
2.Press the guide pins together against the band saw blade.
3.Turn the band saw wheel by hand in a clockwise direction several times to bring the guide pins into the correct position. Both guide pins should just touch the saw blade.
10
