3. Tighten the 2 hex bolts to secure the fence in position.
CAUTION. Only perform miter cuts when the fence is set at the most forward position.
Note. For accurate cuts, test the cutting angle on some similar scrap material and adjust the angle to suit your requirements. The scale is only a guide.
Adjusting the fence
1.The original spacing between the vice and the fence is 175mm.
2.When cutting wider materials the rear fence will need to be adjusted to the rear most position. When cutting narrow work pieces the fence should be positioned in the most forward position.
3.To adjust the fence loosen and remove the two hex bolts securing the fence using the 8mm hex key supplied.
4.Move the fence backwards or forwards to one of the other two fixing positions.
5.Tighten the 2 hex bolts to secure the fence in position.
CAUTION. Narrow work pieces may not be secured safely when using the two wider interval settings.
Turning on and off
1.Plug the cordset into the mains socket.
2.Push the
3.To stop the tool release the trigger switch
4.When you release the trigger switch, the machine turns off and the
Warning. The cutting disc will continue to run down for a short period of time after the trigger swich has been released.
Replacing a cut off disc
CAUTION. Always ensure that the saw is switched off and unplugged from the power supply before installing or removing a disc.
1.Loosen and remove the spark shield locking knob.
2.Swing the front spark shield downwards and pull out from the upper disc guard to reveal the cutting disc bolt and flange.
3.Push the spindle lock lever to the right and rotate the disc until the spindle lock engages.
4.Whilst holding the spindle lock lever use the 8mm hex key supplied to remove the disc bolt. Note that the bolt unscrews in an
5.Remove the disc lock bolt, washer, outer flange, blotter and cut off disc.
9
