Overview
The cut off saw is used for cutting steel such as pipe, box section, rectangular, angle iron and steel bars. The saw can cut at angles from 0° to 45° left and right, it features a two position fence that permits an extended cutting range. The quick release vice allows fast adjustment whilst the
Attaching the rubber feet
1.Tilt the saw onto its side.
2.Take the rubber feet and insert 1 rubber foot into the matching slots on the base of the saw.
3.Ensure the rubber feet are fully inserted into the slots.
4.Repeat for the other side
and place the chop saw back on its base.
Attaching the rear spark shield
1.Loosen and remove the hex bolt, flat washer and star washer at the back of the saw using the 5mm hex key supplied.
2.Place the flat washer over the hex bolt and then fit the hex bolt through the spark deflector, place the star washer over the hex bolt so it is in between the spark deflector and the cut off saw. Place the spark shield in the correct position and tighten the hex bolt.
3.Tighten the hex bolt to secure the spark shield in position.
Adjusting the vice
The vice can be adjusted quickly by loosening the vice lock release lever and pushing forward.
1.Place your workpiece in between the fence and vice.
2.Lift the vice lock release lever and push the vice forward.
3.Once the vice hits the workpiece move the vice lock release lever back down.
4.Rotate the vice handle in a clockwise direction to secure the workpiece in position.
5.To remove an object from the vice, rotate the vice handle in an
also be lifted to slide the vice back quickly.
Note. The vice lock release lever cannot be lifted until the vice jaws are loose.
Adjusting the cutting angle
1.To change the cutting angle loosen the 2 hex screws securing the fence using the 8mm hex key supplied.
2.Move the rear fence to the desired angle using the scale as a guide.
8
