JVC RX-6500VBK manual Basic Settings, Recording a Source, Changing the Source Name, English

Basic Settings

Some of the following settings are required after connecting and positioning your speakers in your listening room, while others will make operations easier.

English

Recording a Source

For analog-to-analog recording

You can record any source playing through the receiver to a cassette deck (or an MD recorder) connected to the TAPE/MD jacks and the VCR connected to the VCR jacks at the same time.

While recording, you can listen to the selected sound source at whatever sound level you like, without affecting the sound levels of the recording.

For digital-to-digital recording

You can record the selected digital input through the receiver to a digital recording device connected to the DIGITAL OUT terminal.

•Analog-to-digital and digital-to-analog recordings are not possible.

•When the source is the digital recording equipment such as an MD, only linear PCM signals can be recorded.

Changing the Source Name

When you have connected the MD recorder to the TAPE/MD jacks or the DBS tuner to the TV SOUND/DBS jacks on the rear panel, change the source name shown on the display when you select the MD recorder or the DBS tuner as the source.

On the front panel ONLY:

When changing the source name from “TAPE” to “MD”:

TAPE/MD

1. Press TAPE/MD.

• Make sure “TAPE” appears on the display. SOURCE NAME

2.Press and hold SOURCE NAME (TAPE/MD) until “ASSGN. MD” appears on the display.

While recording, you can listen to the selected sound source at whatever sound level you like, without affecting the sound levels of the recording.

Notes:

To change the source name from “MD” to “TAPE,” repeat the same procedure above (in step 1, make sure “MD” appears on the display).

When changing the source name from “TV SOUND” to “DBS”:

• The output volume level, tone adjustment (see page 10) and bass

1. Press TV SOUND/DBS.

TV SOUND/DBS

boost (see page 10) cannot affect the recording.

• The following signals do not come out through the DIGITAL OUT

terminal:

• Test tone signal

• Signals processed with the DSP modes

IMPORTANT:

•During recording, do not change the DSP mode (see page 18); otherwise, recording will be interrupted.

•During digital-to-digital recording, do not output the test tone signal (see page 26, 28); otherwise, your recording will be interrupted.

Adjusting the Front Speaker Output

Balance

If the sounds you hear from the front right and left speakers are unequal, you can adjust the speaker output balance.

Before you start, remember...

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

On the front panel ONLY:

1. Press ADJUST repeatedly until	ADJUST
“L/R BALANCE” appears on the

display.

•Once you have pressed ADJUST, MULTI CURSOR %/ Þcan be also used for selecting “L/R BALANCE.”

MULTI CURSOR

2.Press MULTI CURSOR @/ #to adjust the balance.

•Pressing @decreases the right channel output (from “L-21” to “R-21”).

•Pressing #decreases the left channel output (from “R-21” to “L-21”).

• Make sure “TV SOUND” appears on the

SOURCE NAME

display.

2.Press and hold SOURCE NAME (TV SOUND/DBS) until “ASSGN. DBS” appears on the display.

To change the source name from “DBS” to “TV SOUND,”

repeat the same procedure above (in step 1, make sure “DBS” appears on the display).

Note:

Without changing the source name, you can still use the connected components. However, there may be some inconvenience.

–“TAPE” or “TV SOUND” will appear on the display when you select the MD recorder or DBS tuner.

–You cannot select the digital input (see page 14) for the MD recorder and the DBS tuner.

–You cannot use the COMPU LINK remote control system (see page 26) to operate the MD recorder.

11