SECTION
Adjusting Seat Height
NOTE: For this procedure, refer to FIGURE 7.2.
1.Remove the seat. Refer to Removing/Installing the Seat on page 30.
2.Loosen the knob on the frame tube.
3.Remove the locking pin that secures the seat post to the frame tube.
4.Align the frame tube mounting hole with one of three seat post mounting holes to achieve desired seat height.
WARNING
Make sure the detent balls of the locking pin are fully released beyond the outer edge of the frame tube before operating the scooter. Otherwise, injury and/or damage may result.
Keep detent balls clean.
5.Insert the locking pin through the frame tube and seat post. Ensure the detent balls (not shown) of the locking pin are beyond the outer edge of the frame tube and the pin secures the frame tube to the seat post.
6.Tighten the knob until the seat post does not move around inside of the frame tube.
7.Install the seat. Refer to Removing/Installing the Seat on page 30.
Seat Post
NOTE: Knob removed |
|
|
for clarity. The knob |
|
|
does not have to be |
|
|
removed to perform |
|
|
this procedure. | Locking Pin | Mounting |
| Holes | |
|
|
Frame Tube
Knob 
Frame Tube Mounting Hole
