Invacare Lynx L-4 manual Removing/Installing the Front Wheel, Removing/Installing the Drive Wheels

SECTION 9—WHEELS AND CASTERS

NOTE: Front wheel shown.	Keystock	Drive Wheel
Rear wheel installs the same
way.
		Washer
Drive Shaft			Mounting
			Screw
FIGURE 9.1 Removing/Installing the Drive Wheels

Removing/Installing the Front Wheel

NOTE: For this procedure, refer to FIGURE 9.2.

NOTE: This procedure applies to the Lynx L-3 only.

NOTE: Take note of position and orientation of wheel and mounting hardware before removing.

Removing

1.Turn power off and remove the key from the ignition.

2.Place the front of the powered scooter up on blocks so that the front wheel is off the ground.

3.Remove the mounting screw, locknut, two spacers and washer that secure the front wheel to the fork.

4. Remove the front wheel from the fork.

Installing

1.Align the front wheel with the fork mounting holes.

2.Using the mounting screw, locknut, two spacers and washer, secure the front wheel to the fork.

3.Securely tighten the front wheel mounting hardware.

Fork	Fork
Mounting	Fork
Hole
	Mounting
Locknut	Hole
	Front
Washer	Wheel

Mounting

Screw

Spacer

Spacer

FIGURE 9.2 Removing/Installing the Front

Wheel

Lynx™L-3 & Lynx L-4 36 Part No. 1143205