SECTION 10—BATTERIES
Installing
1.Install the two new batteries into the battery box.
2.Secure the thermal switch to the side of the left battery using tape*.
*NOTE: The thermal switch needs to be well secured and in direct contact with the side of the battery. Service tape is available as a service part and is the recommended solution. As an alternate, a heavy duty “duct” styled tape can be used. If “duct” styled tape is used, wrapping the tape completely around the battery with minimal overlap will provide the best adhesion.
3.Connect the wiring harness to the batteries in the following order (Detail “B” of FIGURE 10.3):
A.NEGATIVE
B.POSITIVE (+) RED battery cable to the POSITIVE (+) battery terminal on the right battery.
C.WHITE battery cable (Jumper) to the POSITIVE (+) battery terminal on the left battery and the NEGATIVE
4.Replace the top of the battery box and secure with the twelve mounting screws (Detail “A” of FIGURE 10.3). Securely tighten.
5.Reinstall the battery box on to the scooter frame. Refer to Removing/Installing the Battery Box on page 38.
6.Reinstall the seat. Refer to Removing/Installing/Adjusting the Padded Seat on page 29 or Removing/Installing the Deluxe Seat on page 31.
Detail “A”
Battery
Box Cover
Battery
Box
NEGATIVE | Detail “B” |
|
|
| |
BLACK Battery Cable | Battery | |
|
| |
NEGATIVE | WHITE Battery Cable | Box Cover |
BLACK Battery | (Jumper) | POSITIVE (+) |
Terminal |
| RED Battery |
|
| Terminal |
Cables |
|
|
to |
|
|
Thermal |
|
|
Switch |
|
|
(not |
| POSITIVE (+) |
shown) |
| RED Battery |
|
| Cable |
Battery | Right Battery | |
Left Battery | ||
Box | ||
|
