Invacare Lynx L-4 manual Removing/Installing the Batteries, Removing/Installing the Battery Box

SECTION 10—BATTERIES

DETAIL “A”

DETAIL “B”

Battery Tray

Battery Box Handle Battery Box

Connector on Base

FIGURE 10.2 Removing/Installing the Battery Box

Removing/Installing the Batteries

NOTE: For this procedure, refer to FIGURE 10.3.

Removing

1.Remove the seat. Refer to Removing/Installing the Seat on page 30.

2.Remove the battery box from the scooter. Refer to Removing/Installing the Battery Box on page 38.

3.Remove the twelve mounting screws (not shown) that secure the battery box top to the battery box (Detail “A” of FIGURE 10.3).

NOTE: Mounting screws are located on the underside of the battery box.

4.Disconnect the wiring harness from the batteries by holding the connectors and pulling them in the following order (Detail “B” of FIGURE 10.3):

A.NEGATIVE (-) BLACK battery cable from the NEGATIVE (-) battery terminal on the left battery.

B.POSITIVE (+) RED battery cable from the POSITIVE (+) battery terminal on the right battery.

C.WHITE battery cable (Jumper) from the POSITIVE (+) battery terminal on the left battery and the NEGATIVE (-) battery terminal on the right battery.

5.Remove the tape securing the thermal switch to the side of the left battery.

6.Remove the batteries from battery box by lifting the batteries out.

Part No. 1143205 39 Lynx™L-3 & Lynx L-4