SECTION 12—ACCESSORIES
Installing/Removing the Safety Flag
WARNING
The installation of the safety flag onto the back of the scooter seat significantly increases the length of the scooter. When turning the scooter or swiveling the scooter seat, it is important to take note of this increased length - otherwise, injury and/or damage to the surrounding property may result.
NOTE: For this procedure, refer to FIGURE 12.3.
Installing
1.Install the bracket into the accessory tube located on the back of the seat.
2.Install mounting knob to secure the bracket in place. Securely tighten.
3.Install safety flag into bracket.
Removing
1.Remove the safety flag from the bracket.
2.Remove the mounting knob that secures the bracket in place.
3.Remove the bracket from the accessory tube located on the back of the seat.
Safety Flag
Mounting Knob
Bracket
Accessory Tubes
FIGURE 12.3 Installing/Removing the Safety Flag
Installing/Removing/Using the Walker Holder
INSTALLATION WARNINGS
After ANY adjustments, repair or service and before use, make sure that all attaching hardware is tightened securely.
The installation of the walker holder onto the back of the scooter seat significantly increases the length of the scooter. When turning the scooter or swiveling the scooter seat, it is important to take note of this increased length - otherwise, injury and/or damage to the surrounding property may result.
